Changing the Wiper Blade Rubber

  1. Set the power mode to ON, then to VEHICLE OFF.
  2. Within 10 seconds of setting the power mode to VEHICLE OFF, hold the wiper switch in the MIST position for more than two seconds.
    • Both wiper arms are set to the maintenance position as shown in the image.
  1. Lift both wiper arms.
  1. Press up on and hold the tab, then slide the holder off the wiper arm.
  1. Pull the end of the wiper blade in the direction of the arrow in the image until it is out of the holder’s end cap.
  1. Pull the wiper blade in the opposite direction to slide it out of the holder.
  1. Insert the flat side of the new wiper blade onto the bottom part of the holder. Insert the blade all the way.
  2. Install the end of the wiper blade into the cap.
  3. Slide the holder onto the wiper arm until it locks.
  4. Lower both wiper arms.
  5. Set the power mode to ON, then set the wiper switch to the MIST position once.
    • The wiper arms return to the standard position.
Detail

NOTICE
When lifting the wiper arms, always follow the instructions to move them into the maintenance position.
The wiper arms may be damaged if they are moved manually.

NOTICE
Avoid dropping the wiper arm onto the windshield, as it may damage the wiper arm and/or the windshield.

Recommended topic(s)