Opening/Closing the Panoramic Roof
- WARNING
-
Opening or closing the panoramic roof and sunshade on someone’s hands or fingers can cause serious injury.
Make sure all hands and fingers are clear of the panoramic roof and sunshade before opening or closing it.
- Detail
-
NOTICE
Opening the panoramic roof in below freezing temperature or when it is covered with snow or ice can damage the panoramic roof panel or motor.The panoramic roof and sunshade can be operated for up to 10 minutes after you set the power mode to VEHICLE OFF.
Opening either front door cancels this function.When resistance is detected, the auto reverse function causes the panoramic roof and sunshade to change directions, then stop. Auto reverse stops sensing when the panoramic roof and sunshade are almost closed to ensure that it fully closes.
You can use the remote transmitter or the key to operate the panoramic roof.
You can operate the panoramic roof and sunshade when the power mode is in ON. Use the switch in the front of the ceiling to open and close the panoramic roof and sunshade.
Using the Sunshade Switch
-
Automatic operation
To open: Pull the switch back firmly.
To close: Push the switch forward firmly.The sunshade will automatically open or close all the way. To stop the sunshade midway, push the switch briefly.
Manual operation
To open: Pull the switch back lightly, and hold it until the desired position is reached.To close: Push the switch forward lightly, and hold it until the desired position is reached. -
- Detail
-
The sunshade can be opened or closed to adjust the amount of light that enters the cabin.When you use the sunshade switch to open the sunshade, the panoramic roof does not move.The sunshade cannot be fully closed if the panoramic roof is open. When you close the sunshade with the panoramic roof open, the sunshade stops slightly before the panoramic roof. When you push the switch forward again, the sunshade and the panoramic roof close together.
Using the Panoramic Roof Switch
-
Automatic operation
To open: Pull the switch back firmly.
To close: Push the switch forward firmly.The panoramic roof will automatically open or close all the way. To stop the panoramic roof midway, pull or push the switch briefly.
Manual operation
To open: Pull the switch back lightly, and hold it until the desired position is reached.
To close: Push the switch forward lightly, and hold it until the desired position is reached.Tilting the panoramic roof up
To tilt: Push on the center of the panoramic roof switch.- The sunshade will open automatically and the panoramic roof will start to tilt up.
-
- Detail
-
The panoramic roof cannot be fully opened in a single operation. The panoramic roof has a “comfort” position or wind noise reduction position at which the roof first stops. To open fully, pull the switch back again after the roof has stopped at this position.
Whenever the panoramic roof is opening, the sunshade moves along with it. However, when the panoramic roof is closing, the sunshade does not move.When you tilt open the panoramic roof, the sunshade opens slightly to let in fresh air. When you close the panoramic roof from this position, the sunshade returns to its closed position.When you tilt open or slide open the panoramic roof, if the climate control is set to AUTO it will automatically switch to fresh air mode to reduce wind noise. When you close the panoramic roof, depending on the situation it will change to recirculation or fresh air mode.
* Not available on all models
- Recommended topic(s)
